Find a dealer near you

Direct or prolonged exposure to water or dampness could cause your product to malfunction electronically and mechanically. Water can cause electrical components to corrode and the unit’s frame to rust. Also, if your product is exposed to these conditions, it may affect the status of your product’s warranty. Your power chair should be examined periodically for signs of corrosion caused by water exposure, bodily fluid exposure, or incontinence. Damaged components should be replaced or treated immediately.

If your power chair comes into contact with water:

1. Dry your device as thoroughly as possible with a towel.
2. Allow the product to sit in a warm, dry place for 12 hours to allow unseen water to evaporate.
3. Check the joystick operation and the brakes before using your device again
4. If any inconsistencies are found, take your product to your authorized Quantum provider

Mobility devices that are frequently exposed to sources of liquid, such as incontinence, should be inspected often for corrosion, and electronic components may need to be replaced frequently. If your product is exposed to these conditions, it may affect the status of your product’s warranty.

The serial number for your power chair begins with the letter J and is found on the back of the base of your power chair. Remove the rear shroud and look for a white barcode sticker on the back of the base.

If you have iLevel power adjustable seat height, you can also look for the seating system serial number, which is found by looking up directly under the seat pan. This number begins with a Y and is 14 digits long. You may also find your serial number written on the inside cover of your product’s owner’s manual.

If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag and contact your local waste disposal agency or authorized provider for instructions on disposal and battery recycling, which is our recommended course of action.

When engaged, freewheel levers allow your mobility device to be pushed. Your power chair is equipped with two manual freewheel levers, labeled either locked or unlocked.

Whenever you need or want someone to push your device for short distances, it can put into freewheel mode by having a person push the levers into the unlocked position:

1. Have the person who will push the chair to pull up firmly on the manualfreewheel levers to disable the drive system and the brake system.
2. He or she may push your power chair.
3. Once done pushing the chair, the person should push down firmly on the manual freewheel levers to the locked position, to reengage the drive system and the brake system.